Kala Mistral 1650 and 2100

Everything you need in a single laminator – single side lamination with or without waste paper, simultaneous single side lamination and adhesive mounting, one-run encapsulation, application tape, and mounting on boards up to 50mm thick.

With five roll-shafts and one unwinding shaft, the Kala Mistral range of laminators will be able to keep up with your workflow. You can store up to four film rolls at the base of the machine for ultimate convenience, while the metal feeding tray reduces material waste and saves time when installing film onto the machine. The 50mm opening of the rollers offers a wider range of uses and is perfect for your flatbed printing output.

Your operators will work with the benefit of four levels of protection. A visible laser eye in front of the roller stops the motor when obstructions are detected. Automatic safety cuts the driving motor circuit when the feeding tray is in the up position. Once one of these safety mechanisms has been activated, the reset button on the panel board flashes red, indicating that the system needs reactivating. Additionally, the machine has a sound system to indicate that it’s about to go into reverse.

• Always displayed
• Constantly monitored during production. This results in less wastage of prints.
• Consistently good laminating results
• No skewing of the outputs allowing long job runs
• Stepper motors control roller levels. The space between rollers always same.
• Auto calibration.